Mekleejot info par motora darbiibas speeju palielinaashanu uzduuros shim te:
Can A Stock 16v Exhaust Cam Be Used As An Intake Cam?
-----------------------------------------------------
If you've been reading vortex forum, a tuner/builder/racer of
championship A2s since '90 gave some concrete data concerning
the use of the exhaust cam as the intake cam. Here's his quote:
"If you want some cheap horse power then take a second exhaust cam,
cut off the end and install as an intake(this as 10.2mm of lift over
the 9.6mm euro intake and I think, only 8.8ish on the US spec) you
then re-machine the woodruff key slots in both cams to enable a phase
angle of 106 degrees. You then need to install them with a 106 degree
peak opening point on both symetrically. This coupled with fitting
larger exhaust valve seats that enable the use of the 28mm valve and
not the 27mm seat you have now with your 28mm valve, makes a good 155hp
with a suitable exhaust system. You also get an additional 800rpm
attached to your power band (60% of this at the lower end I may add).
Veeleetos kaada gudraaka par mani speciaalista viedokli shajaa sakaraa, izklausaas jau nu tiiri iespeejami